Synology DS414 Installationsanleitung PDF herunterladen (Seite 7)

7 Chapter 2: Hardware Setup

3 Load hard disks in the hard drive trays.

 For 3.5” Hard Disks: Remove the fastening panels from the sides of the hard drive tray. Place the hard disk

in the hard drive tray. Then insert the fastening panels to secure the hard disk in place.

 For 2.5” Hard Disks: Remove the fastening panels from the sides of the hard drive tray and put them in a

safe place. Place the hard disk in the blue area (shown below) of the hard drive tray, turn the tray upside

down, and then tighten the screws to secure the hard disk.

4 Make sure the side marked with "UP" is facing up, and insert the hard drive tray into the empty hard drive bay.

You should hear a click when the tray is locked into place.

5 Repeat the above steps to install any other hard disks you have prepared.

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Keine Kommentare

Synology DS414 Installationsanleitung Seite 7